Our Heating & Air Conditioning Rough-In Process
Step 1: Consultation & Assessment
Review plans, insulation, ceiling heights, and solar exposure. Coordinate with GC, electrical, and plumbing to align timelines and constraints for a clean, clash-free build.
Step 2: System Design & Planning
Size equipment, calculate CFM, and map ducts, supplies, and returns for balanced comfort. Integrate zoning, variable-speed options, and duct insulation for efficiency.
Step 3: Ductwork & Refrigerant Lines
Install, seal, and insulate ducts to prevent losses. Route and insulate refrigerant lines with leak-free brazing and proper supports for long-term reliability.
Step 4: Vents, Returns & Services
Set supply/return locations per design to eliminate hot/cold spots. Coordinate dedicated circuits, controls, and condensate drains with clean, serviceable routing.
Step 5: Code Compliance & QA
Build to local/state codes. Inspect duct sealing, vent placement, wiring, and drainage before close-up; correct immediately to ensure pass-ready rough-in.
Step 6: Final Tie-In & Maintenance Ready
Connect air handler, condenser, and thermostat for a smooth startup. Provide access points and care guidance to maximize performance and lifespan.